Scada System for a Power Electronics Laboratory

Authors

  • Alejandro Paz Parra Pontificia Universidad Javeriana Cali
  • Carlos Alberto Lozano Pontificia Universidad Javeriana Cali
  • Manuel Vicente Valencia Pontificia Universidad Javeriana Cali

Abstract

Abstract

The present paper shows the design and implementation of a SCADA system enabled to acquire signals from eight power electronics remote units plugged into a CAN bus. The power electronic modules are used for electric power conversion and electric machinery control systems. A 1KW full wave half-controlled rectifier was used as circuit under test to validate the signal acquisition and signal process to obtain the signal average, THD, RMS, and other characteristics. A digital oscilloscope FLUKE43B was used for comparison and validation purposes.

Author Biographies

  • Alejandro Paz Parra, Pontificia Universidad Javeriana Cali

    Ingeniero Electricista M.Sc.
    Grupo de Investigación en Automática y Robótica GAR. Facultad de Ingeniería. Pontificia Universidad Javeriana Cali.

  • Carlos Alberto Lozano, Pontificia Universidad Javeriana Cali
    Ingeniero en Electrónica M.Sc.
    Grupo de Investigación en Automática y Robótica GAR. Facultad de Ingeniería. Pontificia Universidad Javeriana Cali.
  • Manuel Vicente Valencia, Pontificia Universidad Javeriana Cali

    Ingeniero Electricista M.Sc. Grupo de Investigación en Automática y Robótica GAR. Facultad de Ingeniería. Pontificia Universidad Javeriana Cali.

Downloads

Issue

No. 25 (2009): January - June

Section

Articles

How to Cite

[1]
“Scada System for a Power Electronics Laboratory”, Ing. y Des., vol. 25, no. 25, Jun. 2011, Accessed: Oct. 23, 2026. Available: https://rcientificas.uninorte.edu.co/ingenieria/article/view/1577